Hello:
Just downloaded cURL and when I try my first test I get a S0C1 abend. Is there a machine level dependency?
We are running a Z10.
Thanks
Hello:
Just downloaded cURL and when I try my first test I get a S0C1 abend. Is there a machine level dependency?
We are running a Z10.
Thanks
Hello:
Just downloaded cURL and when I try my first test I get a S0C1 abend. Is there a machine level dependency?
We are running a Z10.
Thanks
Hi,
Could you specify the exact archive you have downloaded?
Thanks,
Tatyana
Hi,
Could you specify the exact archive you have downloaded?
Thanks,
Tatyana
curl-7.52.1_b007.180720.tar.gz
It took a dump and if I believe AbendAid it says:
The next sequential instruction to be executed in load module *PATHNAM
was at displacement 00010434 from the load point of the module.
The system completion code of 0C1 is issued when the operation code
detected is invalid or not implemented for this computer model.
The ORK R0,R3,R0 instruction could not be executed because the
z/Architecture Distinct-Operands Facility is not installed on this
system. Display the z/Architecture extensions available at the time of
the abend.
Thanks
Tim Demonbreum
Ingram Entertainment Inc.
tim.demonbreum@ingramentertainment.com
615-287-4681
curl-7.52.1_b007.180720.tar.gz
It took a dump and if I believe AbendAid it says:
The next sequential instruction to be executed in load module *PATHNAM
was at displacement 00010434 from the load point of the module.
The system completion code of 0C1 is issued when the operation code
detected is invalid or not implemented for this computer model.
The ORK R0,R3,R0 instruction could not be executed because the
z/Architecture Distinct-Operands Facility is not installed on this
system. Display the z/Architecture extensions available at the time of
the abend.
Thanks
Tim Demonbreum
Ingram Entertainment Inc.
tim.demonbreum@ingramentertainment.com
615-287-4681
Hi Tim,
Could you install curl-7.52.1_b006.170926.tar.gz and try with this build?
Regards,
Tatyana
Hi Tim,
Could you install curl-7.52.1_b006.170926.tar.gz and try with this build?
Regards,
Tatyana
This build works.
Thanks
Already have an account? Login
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.