Skip to main content

Hi,

I have some packages staying in APR status after approval (no error in distribution).
I read It maybe caused by the influence of asid parameters in the file tailoring service.

Did I well understand ?
If Yes :
1/ please, could you tell where I can verify my current ASID ?
because when i do /f jobname,ASIDS
the response is SER0851W Unrecognized operator command ignored: ASIDS
2/ please, where can I find the sernet keyword option ASID at startup?
3/ Please, Can you tell me about this command : /F jobname,ASID=(64,30) ?

Best regards.


#ChangeManZMF

Hi,

I have some packages staying in APR status after approval (no error in distribution).
I read It maybe caused by the influence of asid parameters in the file tailoring service.

Did I well understand ?
If Yes :
1/ please, could you tell where I can verify my current ASID ?
because when i do /f jobname,ASIDS
the response is SER0851W Unrecognized operator command ignored: ASIDS
2/ please, where can I find the sernet keyword option ASID at startup?
3/ Please, Can you tell me about this command : /F jobname,ASID=(64,30) ?

Best regards.


#ChangeManZMF

Hello William,

The ASIDS modify command was removed in the ZMF 8.2 release.

The ASID start-up parameter is documented in the Sernet Keyword Options section of the ChangeMan ZMF Installation Guide (i.e. Appendix D). The 8.2 Patch 7 version of this manual can be found here: https://www.microfocus.com/documentation/changeman-zmf/8-2-patch-7/pdfs/zmf-installation-guide.pdf.

If you need further assistance on this subject please open a case with our Support team on the following link: https://portal.microfocus.com/s/. If you have any problems with access to that site please contact us using the information available on the following link: https://www.microfocus.com/support-and-services/serena/.

Best regards,

Steve

Terms & ConditionsAccessibility statement