Hi Unifacers,

when using a print instruction in classic mode without 3rd param, Uniface runtime on Windows assumes USE_SYSTEM_SETTINGS=FALSE, not re-reading the spooler default printer.

In a Uniface appl in production since 20+ yrs we would like to have it assuming USE_SYSTEM_SETTINGS=TRUE by default at application wide level. Is there a way either in .INI or .ASN or whatever configuration file to force it in a single place avoiding to manually change 500+ reports?

Thanks in advance for any answer/tip/trick.

Regards,
Gianni

P.S. in .INI file currently used into [Printer] section is already defined defaultprinter=TRUE; this is acting AFAIK at the end of each printout.