As far as I remember:

font0 is the "Canvas font". It defines the screen geometry (and print geometry) within a uniface application. A smaller font results into smaller uniface "cells"

and  A bigger font --> bigger uniface cells. I think the cell size is calculated out of the "M" of the font, which is in "font0".

I currently don't know, where font0 is used else in an uniface application. I would guess in UNIFIELDS...

Three possibilities:

- Try to leave font0 in COURIER NEW  (should cause no major problems, except possibly in unifields and where you assigned font0 directly in the asn-File or the application)

- Play around with the Size of Arial Unicode MS within font0  (as above: a bit bigger number)

- Try to find a font which is Unicode and similar to Courier New.

Attention: Customer needs to have the font also intalled on his machines...

NB: There are two sections in the ini File:  [screen] and [printer]. I would guess for your case: Take a closer look to font0 within the [printer] Section.

Thanks of our answer.

I set in the ini file the same font of U8 and now the print-out are correct. Also, my application in Chinese simplified seem correct.
Regards, Antoine