[SOLVED] 0019 - Component xxx version is incorrect; you must recompile it.
Author: alex.meyers@cevi.be (ceviame)
When did this happen ? i have a mixed environment : 2 projects (X and Y) in 9.5.x, 1 project (Z) in 9.6.01 X and Z use shared components from Y that are in a deployed UAR no problem until i applied mx03 since then i can no longer access anything in Z from the Y uar (and nothing from uSVN) without getting this 0019 error i cannot find anything in doc/patches that explains this change is there a flag that can restore old behaviour ? help, this is APITA Alex
Hello Alex, The components of MX01/9.6.02 (and newer) are not compatible with older versions. When you check the readme of the Service Pack MX03 (mx03w32.txt) then you can find the following note:
(2). Recompilation requirements
-------------------------------
For Uniface 9.6 patches are fully incremental. This means that any newer
patch can be installed on top of an earlier patch or minor version.
For example: It is possible to install patch X301 on top of 9.6.01/patch
X101. Doing so, the installation will automatically be upgraded to
Uniface 9.6.03 with patch X301.
Although we try to prevent a recompilation requirement for a patch or
service pack, a recompilation of the components is sometimes required after
installation.
After installation of MX01/9.6.02 and later patches/service packs, a
recompilation of all components needs to be done if these patches are
installed on top of a Uniface version or patch older than MX01/9.6.02.
Hope this helps. Kind regards, Daniel
Author: diseli (daniel.iseli@uniface.com)
[SOLVED] 0019 - Component xxx version is incorrect; you must recompile it.
Author: alex.meyers@cevi.be (ceviame)
When did this happen ? i have a mixed environment : 2 projects (X and Y) in 9.5.x, 1 project (Z) in 9.6.01 X and Z use shared components from Y that are in a deployed UAR no problem until i applied mx03 since then i can no longer access anything in Z from the Y uar (and nothing from uSVN) without getting this 0019 error i cannot find anything in doc/patches that explains this change is there a flag that can restore old behaviour ? help, this is APITA Alex
"9.5.x, 1 project (Z) in 9.6.01" Mixing components compiled between point versions, for example 9.5 and 9.6 is always a no-no. I'd say in the case of 9.6, the risk of crashes, corruption, etc is significant because of all of the GUI enhancements that were delivered and there was a huge amount of code re-factoring as a result of the 64 bit windows project.
Author: Adrian Gosbell (adrian.gosbell@synapse-i.jp)
