Skip to main content

[Migrated content. Thread originally posted on 24 September 2004]

Hello,

I am just getting Started with AcuBench and its going fairly well.

Is it possible to have a screen that displays a tab control within a larger "Main" tab control? I've built it in the screen designer and it compiles without error but only the "Main" tab control (and some other unrelated controls) is displayed when executed.

Any insight would be appreciated!

Mick

[Migrated content. Thread originally posted on 24 September 2004]

Hello,

I am just getting Started with AcuBench and its going fairly well.

Is it possible to have a screen that displays a tab control within a larger "Main" tab control? I've built it in the screen designer and it compiles without error but only the "Main" tab control (and some other unrelated controls) is displayed when executed.

Any insight would be appreciated!

Mick
Attached is a sample program that displays a tab on a tab.
I didn't write the program and I can't remember where I picked it up from, but hopefully it will help you.

[Migrated content. Thread originally posted on 24 September 2004]

Hello,

I am just getting Started with AcuBench and its going fairly well.

Is it possible to have a screen that displays a tab control within a larger "Main" tab control? I've built it in the screen designer and it compiles without error but only the "Main" tab control (and some other unrelated controls) is displayed when executed.

Any insight would be appreciated!

Mick
Thanks a ton,

The sample seems to be made for AcuCobol-GT and I'm using AcuBench. At least I know it can be done! I'll disect it more next week and see if I can figure out how. This was very helpful.

Thanks again,

Mick
Terms & ConditionsAccessibility statement