Skip to main content
Hi,

What is the correct way to reset page headers and numbers when using the
BASIC "HEADING" statement after issuing a PRINTER CLOSE statement?

We have a program that generates multiple reports based on the same
SELECT list.???? Each report must start at page number 1.

The only time it works is by issuing the following statements:

* PRINTER ON
* HEADING ......
* PAGE 1

This, however, generates a blank first page on each report.

How can we correct this?

--
Best regards and keep safe,

Vincent ???Kim??? Elliott
ITC Coordinator
Bearings & Accessories Ltd.
83 Harbour Street
Kingston
Jamaica, W.I.

Tel: 876-922-1950
Cell: 876-315-2739
Email:vincent.e@bearingsandaccessories.com
Hi,

What is the correct way to reset page headers and numbers when using the
BASIC "HEADING" statement after issuing a PRINTER CLOSE statement?

We have a program that generates multiple reports based on the same
SELECT list.???? Each report must start at page number 1.

The only time it works is by issuing the following statements:

* PRINTER ON
* HEADING ......
* PAGE 1

This, however, generates a blank first page on each report.

How can we correct this?

--
Best regards and keep safe,

Vincent ???Kim??? Elliott
ITC Coordinator
Bearings & Accessories Ltd.
83 Harbour Street
Kingston
Jamaica, W.I.

Tel: 876-922-1950
Cell: 876-315-2739
Email:vincent.e@bearingsandaccessories.com
Hi,

the PAGE statement resets page numbers and also prints a new Heading where set.
I recall that the HEADING Page PL Worked fine, but the FOOTING Page PL started at 0 not 1

Merry

------------------------------
Merry Player
Pick Multivalue Person since CMC (1978) /Microdata/McD/Northgate and onwards Reality/Zebra/Mentor/Ultimate/Universe/Unidata into Pick, Pick AP, and so on up until 2021 on mvBase/D3 - so far ....
Isle of Wight England
------------------------------
Terms & ConditionsAccessibility statement