Getting file Open issue when program thru micro focus dialect

Forum|Forum|3 years ago
June 1, 2022
1 reply
0 views

Dominique Sacre
Rocketeer

My program reading the sequential file (flat) and writing the same thing into output file (flat). This one got executed when I tried with ZOS Enterprise Dialect.

However if I compiled thru Micro focus dialect getting incompatible issue and getting file status as 47.

We tried in Input and I-O modes, Getting same issue for both the modes.

Could you please help me out.

Thanks,

Venu

#EnterpriseDeveloper

+2

Kim Hoskin
Moderator
Forum|Forum|3 years ago
June 1, 2022

My program reading the sequential file (flat) and writing the same thing into output file (flat). This one got executed when I tried with ZOS Enterprise Dialect.

However if I compiled thru Micro focus dialect getting incompatible issue and getting file status as 47.

We tried in Input and I-O modes, Getting same issue for both the modes.

Could you please help me out.

Thanks,

Venu

#EnterpriseDeveloper

Hi, I recommend you to check the following.

See documentation URL:
www.microfocus.com/.../HRFLRHFSTA01.html

That shows:
47 - A READ or START operation has been tried on a file not opened INPUT or I-O.

I recommend you to review your code and adjust that if/as needed, e.g. open the file for INPUT or I-O, then confirm if the issue persists.

If you require further assistance then I recommend you to consider raising a support case where an engineer can assist you.