In upgrading Uniface software from version 10.3.02 to 10.4.02, are the migration settings in the logicals section of the assignment file still needed? They were used when upgrading from 9.7 to 10.3 so I wouldn't think they would continue to be needed since the repository has already been migrated to version 10.
Thank you in advance.
In upgrading Uniface software from version 10.3.02 to 10.4.02, are the migration settings in the logicals section of the assignment file still needed? They were used when upgrading from 9.7 to 10.3 so I wouldn't think they would continue to be needed since the repository has already been migrated to version 10.
Thank you in advance.
The current Uniface 10 migration logical are only used when object definitions created with a previous version of Uniface (i.e. 9.6 or 9.7) are detected . In case you never will import anything again from version 9 into your Uniface 10.4 environment then these logicals could be seen as "obsolete".
But, as mentioned, the logicals are only used when object definitions are detected that need to be migrated. Otherwise the IDE will not use these logicals.
I hope this clarifies this matter.
The current Uniface 10 migration logical are only used when object definitions created with a previous version of Uniface (i.e. 9.6 or 9.7) are detected . In case you never will import anything again from version 9 into your Uniface 10.4 environment then these logicals could be seen as "obsolete".
But, as mentioned, the logicals are only used when object definitions are detected that need to be migrated. Otherwise the IDE will not use these logicals.
I hope this clarifies this matter.
Thank you, Daniel. This clarifies the matter perfectly.
Already have an account? Login
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
77 4th Avenue
Waltham, MA 02451 USA
