$ude("compile",...) IDF crash with the first call to procedure after $UDE

Hi Freaks

Could it be that a program crach after using $ude?
Or better: Yes it crash without any reason (just check in Uniface 9, but I observer this behavior also im UnifAce 10)

I do have a simple form, which list all globale procedures.
Then I use a button "Compile" which goes through the entry and compiles a procedure with
      $1 = $ude("compile", "proc","%%ULABEL.UPRC%%%","library=%%UVAR.UPRC%%%")
(I create a view UPRC to be compatible to Uniface 10)
After the loop all looks okay, until the first call to a global procedure is executed.
(This procedure is not related to they just compiled ones)
Uniface try to call the procedure (can be seen in the proctracing) but crash immediately without any further information

Ingo

I use $ude alot, in loops too, without any problems.... v10 

My next step would be to compare using a hex editor the .prc of the 2 versions(working one and broken one)

Hi

I could loops through hundreds of "objects" like global procedures and UnifAce will compile them.
But the next call to a procedure after the loop crash UnifAce.

FORENTRY "objects"
 $1 = $ude("compile", ...)
ENDFOR
call GP_HELLO_WORLD("")  ; <----------- Crash

Ingo

I did the same test as above(forentity) for 2 global procs... and it worked

*I did the test via the ide and as a standalone application

------------------------------
Osman Shariff
------------------------------

...
Compile Global Proc module: 'GP_DTFELDER'
Global Proc module: GP_DTFELDER
Compile done:  No compilation messages

 (); DETAIL; 11; [0]; V_PE = $procerror
 (); DETAIL; 12; [0]; reset $procerror
 (); DETAIL; 13; [0]; if (V_PE < 0)
 (); DETAIL; 19; [0]; else 
 (); DETAIL; 20; [0]; fieldvideo "ULABEL.UPRC", "DEF"
 (); DETAIL; 21; [0]; C_CHECK.UPRC/INIT = 0
 (); DETAIL; 22; [0]; endif 
 (); DETAIL; 23; [0]; endif 
 (); DETAIL; 24; [0]; endfor 
 (); DETAIL; 6; [0]; forentity "UPRC"
 (); DETAIL; 25; [0]; debug 
 (); DETAIL; 26; [0]; call GP_ABOUT("") ; <- first call to a procedure
-- nothing more to come here --

neither the call itself is made (show me lines in GP) nor an error is returned and the next step is executed
If I change the number of parameters instead, UnifAce reports this correctly when calling GP_ABOUT :
But then UnifAce crashes at the next CALL GP_xyz

Hi Ingo,

IMHO you should compare your Uniface config (INI + ASN) to a working environment like the one from Osman.

Regards,
Gianni

I presume it works if there are no occurrences in "objects" ?

Did you try running it from the ide... compile/test frm ?

did you try :

call GP_HELLO_WORLD("") 

FORENTITY "objects"
 $1 = $ude("compile", ...)
ENDFOR
call GP_HELLO_WORLD("")  

------------------------------
Osman Shariff
------------------------------